R5913197 /02 SP2K-S68
The 3D interface port is disabled if the projector is in ECO mode.
USB port
The Cinema Controller is equipped with a master USB port, type “A” connector. This USB port will simplify the
service procedures for firmware updates or for downloading the log files without a network connection.
If the only file on the USB device is the firmware file (a “*.fw” file), the projector will automatically start one of
the following processes.
• samba<version nr>.fw: The projector will upgrade or downgrade, depending on the version number.
Make sure that any used USB-stick is FAT32 compatible and contains no other files or folders.
Input & communication
To Next Page
Loading...
