AW00123409000 Features
Basler ace USB 3.0 239
The current frame start trigger count of Counter 2 is found to be 1. The Counter Duration setting,
applicable to sequencer set 1 and defining the maximum Counter 2 count, is also found to be
1. Accordingly, the Counter 2 count related to sequencer set 1 has already reached its maximum
and must start again with the next frame acquisition.
When the Sequencer Mode parameter value is set to Off the sequencer feature becomes
disabled for the application of sequencer sets during image acquisitions. The sequencer
parameter values that were the current ones before the sequencer feature was enabled, are
loaded into the active set again. The sequencer set 1 parameter values in the active set are
overwritten.
To Next Page
Loading...
Need help?
General
