AW00123409000 Revision History
Basler ace USB 3.0 355
cont’d
Removed pixel formats RGB 8 and BGR 8 from Table 7 on page 12.
Modified the sensor size for the acA1600-20um in Section 1.2 on page 2.
Removed the availability of CS-mounts for acA1920-20um/uc cameras in
Section 1.2 on page 2 and added a related note in Section 1.4.1 on
page 36.
Indicated UL certification for cameras in Section 1.2 on page 2.
Added a note about the availability of CE conformity declarations to the
tables in Section 1.2 on page 2.
Added information about the availability of pylon for Linux in Section 1.2 on
page 2.
Added information about mechanical stress tests in Section 1.6 on page 43.
Added max. ambient temperature (UL 60950-1) in Section 1.9.1 on
page 46.
Added information in Section 2 on page 43 and Section 6.10 on page 167
about restricted initial maximum allowed acquisition frame rates for
acA2000-165u and acA2040-90u cameras.
Added an explanation about the pylon Viewer’s significance for the camera
configuration mechanism in Section 3.1.1 on page 46
Modified the descriptions of voltage requirements in Section 5.7.1 on
page 59, Section 5.8.1 on page 62, Section 5.9.2 on page 67, and
Section 5.9.3 on page 69.
Added a note about the occurrence of a frame acquisition when enabling or
disabling the inverter in Section 5.11.3 on page 81 and Section 5.12.5 on
page 89.
Added a note in Section 5.12.6.1 on page 90 about the triggering of Timer 1
in the absence of a flash window start signal.
Revised Section 5.13 on page 92.
Added trigger sources for the frame start trigger in Section 6.4.1.2 on
page 115.
Added in Section 6.6.2 on page 134 a note about the unavailability of the
flash window signal in ERS mode when very short exposure times are
used.
Updated the maximum allowed gain settings for acA3800-14u and
acA4600-10u cameras in Table 36 on page 198.
Added Section 8.6 on page 216 describing the sequencer feature.
Added a section about the effective image ROI in Section 8.7.4 on
page 249.
Added a note about the unavailability of vertical and horizontal binning by 3
for acA3800-14um cameras in Section 8.7.1 on page 245.
Added a note about checking ROI settings when changing a binning
parameter value in Section 8.7.4 on page 249.
Highlighted the distinction between "active set" and "active user set" in
Section 8.17 on page 290.
Added the Line Status All chunk as Section 8.18.3.2 on page 299.
Doc. ID Number Date Changes
To Next Page
Loading...
