Revision History AW00123409000
356 Basler ace USB 3.0
AW00123405000 18 Dec 2015 Minor changes and corrections throughout the manual.
Added information for the following new cameras: acA640-750u,
acA800-510u, acA1300-200u, acA1920-40u, acA1920-150u, 1920-155u,
and acA2500-60u throughout the manual.
Indicated the housing temperature measuring point in Section 1.11.2 on
page 50.
Allotted camera specifications and spectral response curves to different
sections, according to sensor technology (CCD, CMOS) in Section 1.2 on
page 2 and Section 1.3 on page 22.
Included information about changed effective Bayer filter alignment with
mirror images in Section 1.2 on page 2, Section 7.1.2 on page 195, and
Section 7.11 on page 260
Added the "Over Temperature Behavior" Chapter 1.11.3 on page 51.
Re-phrased Chapter 3 on page 61.
Removed the reference to DG001115 in Section 2 on page 59.
Added a note in Section 6.6.2.3 on page 151 about the unavailability of the
flash window signal in ERS mode when very short exposure times are
used.
Modified Section 6.8.1 on page 161 to distinguish between involvement of
opto-isolated and GPIO lines.
Indicated the logical meanings of ExpAc levels in Section 6.8.1 on
page 161. Corrected info box in Section 6.8.1 on page 161: The
acA1920-25 and acA2500-14 cameras are no longer listed as lacking the
exposure active signal.
Included information about removing artificial color shift in Section 7.3.1 on
page 198.
Replaced
AOI by ROI in code snippets in Section 7.15 on page 294.
Added the "Pattern Removal" Section 7.15.8 on page 309.
Added information in Section 7.18 on page 317 about operation with 10 bit
output and indicated activation of test image 2 by over temperature mode.
AW00123406000 21 Dec 2015 Removed information about the acA645-100um/uc throughout the manual.
Doc. ID Number Date Changes
To Next Page
Loading...
