Basler acA2040-55 - Page 372

Index AW00123409000
362 Basler ace USB 3.0
I
I/O
cable ..................................................70
line status.........................................103
image quality............................................50
input
direct-coupled (GPIO)........................80
opto-isolated ......................................72
input line
configuration ......................................91
debouncer..........................................92
inverter...............................................94
internal temperature (core board) ............51
IR cut filter................................................42
cut off.................................................32
transmission.......................................32
IR-cut filter..............................................277
L
LED indicator .....................................67, 69
lens mount
C-mount.......................................39
, 40
CS-mount.....................................39
, 41
lens thread length (maximum allowed) ....42
licensing
LZ4.....................................................47
light source
color temperature.............................284
Daylight 5000 K................................284
Daylight 6500 K................................284
Off....................................................284
preset...............................................284
Tungsten 2800 K..............................284
light source preset..................................284
line mode .................................................79
line pitch.................................................334
line status all chunk................................340
LPS
see power supply...............................56
luminance lookup table ..........................266
LUT ........................................................266
M
mechanical stress tests............................46
mirror image...........................................260
mode
acquisition........................................109
binning .............................................247
demosaicing .................................... 283
exposure.......................... 112
, 129, 130
exposure overlap time..................... 135
line..................................................... 79
over temperature....................... 52
, 217
sensor readout ................................ 144
shutter ............................................. 145
trigger .............................................. 110
mount
see lens mount
mounting instructions............................... 44
mounting points....................................... 39
mounting screw holes.............................. 39
N
noise reduction...................................... 281
O
optical format
see optical size
optical size................................................. 4
opto-isolated input ................................... 72
opto-isolated output................................. 74
output
direct-coupled (GPIO) ....................... 82
opto-isolated...................................... 74
output line
configuration...................................... 95
inverter ............................................ 100
timer ................................................ 101
output signal
exposure active............................... 148
over temperature
behavior............................................. 51
mode ......................................... 52
, 217
overheating.............................................. 51
P
pattern removal...................................... 309
PGI feature set .............................. 281
, 293
pin assignment (6-pin connector) ............ 68
pin numbering (6-pin connector).............. 68
pixel format................................................ 4
primary color.................................. 286
, 288
propagation delays.................................. 84
pulse width (minimum)............................. 95