Becker BD406 - Page 87

Becker Avionics
DV16401.03 Issue 04 May 2021 BD406/PBD406 87
Error ID
Display
Description/Action
9
ERR
-
09 01/
03
CONFIGURATION
SETTINGS ERROR
Long press STO
to load default
• Integrity of configuration settings is compromised.
• Data are lost.
• Contact service.
10
ERR
-10 01/03
OPERATION LOG
DATA ERROR
Press STO
to confirm
• Operation data integrity error.
• Data are lost.
• Contact service.
11
ERR
-11 01/03
NAVPOINTS DB
FAILED
Long press STO
to clear DB
• NavPoint database integrity error.
• Data are lost.
• Contact service.
12
ERR-12 01/03
GPS COMM
ERROR
Press STO
to confirm
• GPS communication is lost. Internal or external GPS
receiver does not supply valid transmission. Make sure that
correct source is selected in installation setup.
• Contact service.
WARN-
01
WARN-01 01/03
NEW BEACON
OVERWRITES OLD
Press STO
to confirm
Warning is shown:
• In installation setup at FULL DB CONF screen STORE
NEW BEACON is selected.
AND
• Database is full.
AND
• New message from unregistered in database beacon is
received by the device.
• Push STO to confirm.
WARN-
02
WARN-02 01/03
NEW BEACON
IGNORED
Press STO
to confirm
Warning is shown:
• If in installation setup at FULL DB CONF screen IGNORE
NEW BEACON is selected.
AND
• Database is full.
AND
• A new message from unregistered in database beacon is
received by the device.
• Push STO to confirm.
-
WARNING 01/01
NEW BEACON
DETECTED
Press STO
to confirm
Warning is shown:
• When a new message from not registered in database
beacon is received.
• Push STO to confirm.
-
INVALID INSTALL
DATA
LONG STO – DEFAULT
WARNING
• Shown only in installation setup when CH or CM installation
data are corrupted (CRC error occurs).
• Contact service.