Calibrator Set Point Modifications
Modifying Calibrator Set Points
UniCel DxC Systems Instructions For Use A13914 Reagent Load/Calibration
October 2005 Page 5-31
5
5 Move the cursor to the set point to be modified and type in the desired
value.
If a previously modified set point is to be returned to the original default
value for that calibrator or chemistry, select desired chemistry, move
cursor to the applicable set point and select <Restore Defaults>.
The default values have more significant figures than shown on the screen.
Therefore, select <Restore Defaults>, rather than typing the default
values.
6Select <Close> to exit the screen.
Calibration status changes to Cal Required. (Status changes only for those
containers with the same lot number.)
A flag indicating that specific set points have been modified will appear in
the Instrument Code section on the results report.
Step Action, continued
(2 of 2)
To Next Page
Loading...
Need help?
General
