Displaying Recalled Results
Introduction
UniCel DxC Systems Instructions For Use A13914 Results Recall
October 2005 Page 8-7
8
Displaying Recalled Results
Introduction
All recalled results may be viewed on the screen.
Displaying Results
Follow the steps below to view results on the screen.
Step Action
1 From the Recall Results By screen, select the results to be viewed, as
previously described in this chapter.
2Select Results [F1] to view requested samples.
3 Use the Up or Down arrows to view additional pages of the same sample.
4 If there are tests running, Recall [F2] is available. Select Recall [F2] to
update the sample on the screen with new results since the sample was first
shown.
5Select Prev [F3] to view the Absorbance versus Time plot.
OR
Select [F4] to edit.
OR
Select [F6] to send results to the host.
OR
Select [F7] to print.
OR
Select Prev [F8] to view a previously shown sample.
OR
Select Next [F9] to view other samples if more than one sample result was
recalled.
OR
Select [F10] when done.
To Next Page
Loading...
Need help?
General
