Units/Precision Setup
Introduction
UniCel DxC Systems Instructions For Use A13914 System Setup Options
October 2005 Page 4-31
4
Units/Precision Setup
Introduction
The Units/Precision option allows the operator to select the units and number of
decimal places for each viewed and printed result.
When the units are altered, all features affected by the change, such as reference
ranges and calibration values, will automatically convert to match the new units.
Units cannot be changed for chemistries that are defined for a control in QC.
Setup
From the Setup screen, select <14> Units/Precision to modify units and number of
decimal places or to restore defaults.
The Unit Selection/Precision may be viewed at any time.
The system must be in Standby or Stopped to change unit selection or decimal places.
Refer to the default chemistry units and precision in Table 4.1.
To Next Page
Loading...
Need help?
General
