Routine Operation Overview
Daily Procedure
UniCel DxC Systems Instructions For Use A13914 Preparing Samples for Analysis
October 2005 Page 3-1
3
CHAPTER 3 Preparing Samples for Analysis
Routine Operation Overview
Daily Procedure
The following table shows an example of daily work flow using the DxC Synchron
Clinical Chemistry System.
NOTICE
This procedure assumes that the initial system setup has been completed.
Step Action
1 If necessary, start the system.
2 Check reagent status. Load reagent as necessary.
3 Check calibration. Program or load calibrators as needed.
4 Program or load controls, if required.
5 If the system is not already running, press the RUN button on the system.
6 Check the control results to verify system operation.
7 Program or load patient samples.
8 If the system has gone into Standby, press the RUN button on the system.
9 Review the patient results.
10 Return to Step 7 if more samples need to be run.
11 The system will automatically return to Standby when all testing has been
completed.
To Next Page
Loading...
Need help?
General
