Auto Serum Index/ORDAC
Auto Serum Index
System Setup Options UniCel DxC Systems Instructions For Use A13914
Page 4-6 October 2005
Auto Serum Index
The Auto Serum Index function, when enabled, automatically analyzes every sample
for the detection of hemolysis, icerus and lipemia and numeric values (index) for the
relative concentrations (range) are included in the report.
The values are printed below the Special Calculations area of a patient report. The
values are printed with the test results for a control sample.
Auto Serum Index is intended for sample integrity assessment only; not for patient
diagnosis.
For additional information on Serum Indexing, refer to the Synchron Clinical Systems
Chemistry Information Manual.
From the Setup screen, select <1> Auto Serum Index/ORDAC to enable/disable
Auto Serum Index.
To enable or disable Auto Serum Index, the system must be in Standby or Stopped.
The default for Auto Serum Index is OFF.
NOTICE
When running the system with Automatic Serum Index enabled, remember to
manually disable the serum index feature when choosing options to set the
replicates. This prevents running indices needlessly.
To Next Page
Loading...
Need help?
General
