AeroNav 900/880 Series Pilot’s Guide
89000039-010
Rev 1 May 2019 Navigation 6-31
CAUTION
VTF Transitions
VTF transitions in the AeroNav provide guidance to
the extended final approach course.
When assigned a VTF clearance on an SBAS
approach (WAAS- or EGNOS-based LPV, LP and
LNAV/VNAV) with an offset leg into the Final
Approach Fix (FAF) where the leg to the FAF is not
aligned with the final approach course (i.e. an
angled entry to the FAF), the pilot should ask the
ATC controller to clarify if those vectors are to
extended final or the published offset inbound leg to
the FAF.
In the case where ATC responds with the extended
final scenario, BendixKing recommends the pilot
select the “Vectors” transition option in the FMS
approach dropdown. In the case where ATC
responds with the published offset leg scenario,
BendixKing recommends the pilot activate the
inbound leg to the FAF from the FMS FPL tab to
ensure the offset leg is accounted for.
To Next Page
Loading...
