AeroNav 900/880 Series Pilot’s Guide
89000039-010
7-40 General Rev 1 May 2019
AeroNav Glove Qualification Procedure
Touch the standby frequency window
and verify a virtual keyboard is
displayed. †
Type 121.7, press the "ENTER" button
on the virtual keyboard and confirm
121.700 is the displayed frequency in
the #1 Standby Com window. †
Press each of the page tabs displayed
on the present page and verify the
AeroNav changes to the selected tab.
With the FMS FPL tab displayed, use
touch to type in a typical flight plan and
verify that all entries were recognized.
With the Map page and tab displayed,
attempt to pan the map.
With the Map page and tab displayed,
attempt to pinch zoom (in or out) the
map to produce a range change.
With the Map page and tab displayed,
attempt to graphically flight plan ("rubber
band") and verify the intended change
was made.
Press the "Freq" function key on the
bezel and then double tap a frequency
from the list to place it into the #1
standby slot. †
To Next Page
Loading...
