AeroNav 900/880 Series Pilot’s Guide
89000039-010
Rev 1 May 2019 General 7-61
Upload Complete Indications
When all loading operations have been completed, press the
“Done” LSK to restart the AeroNav in flight mode. Remove the
USB fob and store it in a safe place. If the USB fob is
inadvertently left in the USB port during flight mode, there will be
no adverse affect as the USB fob is ignored during flight mode.
Once the AeroNav is back into flight mode, It is highly
recommended to verify that the data was updated by going to the
AUX-SYS tab, selecting "Databases" with the “Status” LSK, and
then checking the identifying characteristics of the databases that
were loaded (e.g. name, cycle dates).
To Next Page
Loading...
