AeroNav 900/880 Series Pilot’s Guide
89000039-010
Rev 1 May 2019 System Overview 1-41
Pressing it a second time will step the reverse video over
the Arrival field and present a drop down box of available
published arrivals. Each subsequent press of the
“PROC” key will step through all following destination
airfield approaches and arrivals in the flight plan and
wrap back around to the top of the flight plan. When the
drop down box appears over the intended data field, twist
the bottom right AeroNav knob to scroll up or down the
list until the desired procedure is highlighted and then
push the knob in to add that procedure to the flight plan.
If there is no flight plan, pressing the “PROC” key will
present the FPL tab with an insert cursor at the top of the
page but will not present any procedures.
ENTR – The use can vary slightly depending on the
scenario, but “ENTR” is always related to the
Enter/Accept/Confirm use;
CLR – The use can vary slightly depending on the
scenario, but ”CLR” is always related to
Clear/Backspace/CAS Message Clear use.
To Next Page
Loading...
