1 Trough 2 Lashing eyes 3 Pivot
4 Frame 5
Lifting cylinder
holder 6 Support
7 Hydraulic cylinder 8 Block 9 Cab protection wall
The rear tipping trough is used for holding, transporting and tipping loose
bulk materials. The cab protection wall (9) prevents materials falling onto
the operator's cab.
The trough (1) is connected to the frame (4) by pivots (3). The tipping move‐
ment is performed using the hydraulic cylinders (7). The hydraulic cylinders
are connected to the trough by pins and are connected to the frame by the
lifting cylinder
holders (5). The trough rests on the blocks (8) when it is low‐
ered.
When raised, the trough can be secured with the supports (6) to prevent it
from moving downwards inadvertently.
The trough provided with lashing eyes (2) in order to secure the load if
required.
50-020-1011-900_EN
1.0 - © 2/15/2017
129
5 Structure and function
5.3 Technical description of the bodies
To Next Page
Loading...
