At least once each shift, check the machine for damage and defects that
can be seen from the outside. This includes, for example, checking for leaks
in the hydraulic system as well as the general cleanliness of the machine.
Any changes that are found (including in the operating behavior) must be
reported to the shift supervisor immediately. If necessary, stop the machine
immediately and secure it. Immediately repair malfunctions.
3.23 Selection of personnel
Obligations for the selection and qualification of operating personnel:
n Only professionally qualified, experienced and reliable operators are
allowed to work with the machine; these operators must be familiar with
the corresponding technical terms and working procedures.
n The prescribed statutory minimum age must be complied with in accord‐
ance with local regulations.
n The owner/user must define the responsibilities of the operator for trans‐
port, assembly/disassembly, operation, maintenance and disposal.
n The trained specialist personnel allocated to the work must be trained or
instructed in the activities in question. Operators who are to be trained
or instructed are only allowed to work with the machine if constantly
supervised by an experienced person.
n The owner/user must ensure that the corresponding activities are only
carried out by trained specialist personnel who have been allocated to
the task.
50-020-1011-900_EN
1.0 - © 2/15/2017
85
3 Safety
3.23 Selection of personnel
To Next Page
Loading...
