Bernette Chicago 7 - Page 12

10
Machine Setup
When the bobbin winder spindle is pushed to the right
(bobbin winding position), this message is shown on the
LCD display. It will disappear from the LCD display when the
bobbin winder spindle is pushed back to the left into the
sewing position.
• Cut the thread near the hole of the bobbin.
• Continue filling the bobbin until it is full.
– The motor stops automatically when the bobbin is
full.
• Press the Start/Stop button or release the foot control
to stop the machine.
• Push the bobbin winder spindle to left.
• Cut the thread and then remove the bobbin.
• Hold the thread tail securely in one hand.
• Press on the foot control or the Start/Stop button to
start winding the bobbin.
– After the bobbin has wound a few turns, stop the
machine.
Note
502020.83.11_2013_06_bernette chicago 7_EN