Bernette Chicago 7 - Memory Editing Functions - Change a Stored Stitch or Its Parameters

79
Special Functions
• Press the memory button to enter the Memory Mode.
• Use the arrow buttons to choose the desired Memory
file.
• Press the OK button to enter the selected Memory file.
– The cursor stays at the first position.
• Use the arrow buttons to select the stitch that should
be replaced or have its parameters changed.
• To change the stitch press the clr button and then
press the pattern group selection button to choose a
new stitch.
• To change its parameters press the stitch length, stitch
width, mirror image, double needle or elongation but-
ton.
Memory Editing functions - Change a stored stitch or its parameters
Requirement: with existing patterns in Memory.
Note
502020.83.11_2013_06_bernette chicago 7_EN