Bernette Chicago 7 - Needle Threader

14
Machine Setup
Needle Threader
• Lower the needle threader lever slowly and pull the
thread through the thread guide as illustrated and then
to the right.
AtteNtioN!
Raise the needle to its highest position and lower the
presser foot.
Turn power switch to the off position «O»!
• The needle threader automatically turns to the thread-
ing position and the hook pin passes through the
needle eye.
• Pull the thread to the right, guiding it to the front of the
needle
• Hold the thread loosely and release the lever slowly.
– The hook will turn and pass the thread through the
needle eye forming a loop.
– Pull the thread through the needle eye.
AtteNtioN!
502020.83.11_2013_06_bernette chicago 7_EN