Bernette Chicago 7 - Attaching the Embroidery Hoop; Removing the Embroidery Hoop

94
Embroidery Setup
Attaching the embroidery hoop
Removing the embroidery hoop
• Raise the presser foot.
• Place the embroidery hoop under the presser foot.
• Attach the embroidery hoop, plug the embroidery hoop
connector into the hoop securing lever from the front to
the back until it clicks.
• Raise the presser foot.
• Press the snap on the embroidery hoop holder down.
• Pull the hoop towards you smoothly and carefully.
502020.83.11_2013_06_bernette chicago 7_EN