Bernette Chicago 7 - BERNINA Cutwork Tool; Preparation

111
Embroidery Selection
BERNINA CutWork Tool*
* The BERNINA CutWork Tool accessory is optional. It is not included with this machine.
Turn power switch to off («O») when carrying out any of the
following operations.
Preparation
Attach the Darning/Embroidery foot
• Loosen the needle clamp screw (a) to remove the
needle.
• Insert the CutWork Tool with the flat side back, fully up
to the top (b).
• Tighten the needle clamp screw (a) again.
• Attach the embroidery module
In CutWork Mode the upper thread sensor is disabled.
When a CutWork Design is selected the machine makes all
necessary settings automatically.
AtteNtioN!
Note
Note
502020.83.11_2013_06_bernette chicago 7_EN