15
Machine Setup
Replacing the Needle
Thread Cutter
Change the needle regularly, especially if it is showing signs of
wear and tear or of it is causing problems.
Insert the needle following the illustrated instructions.
A Loosen the needle clamp screw and tighten it again
after inserting the new needle. The flat side of the shaft
must be at the back.
B Insert the needle as far up as it will go.
The thread cutter serves two purposes:
1. Cut the thread after threading the needle
2. Cut the thread after finishing a seam.
• To cut the thread after completing your work raise the
presser foot.
• Remove the fabric, draw the threads to the left side of
the face cover and cut using the thread cutter.
• The threads are cut at the proper length to start the
next seam.
Needles must be in perfect condition
Problems can occur with:
– Bent needles
– Blunt needles
– Damaged points
Turn power switch to off («O») when carrying out the
following operation!
AtteNtioN!
502020.83.11_2013_06_bernette chicago 7_EN
To Next Page
Loading...
