Bernette Chicago 7 - Page 48

46
Basic Sewing Procedures
• Raise the presser foot and cut the thread.
• To sew over same buttonhole, raise the presser foot (it
will return to original position).
• After sewing the buttonhole, raise the buttonhole lever
until it stops.
• Cut the slit of the buttonhole being careful not to cut
any stitches on either side.
• Use a pin as a stopper at the bartack so you do not cut
too much.
When having finishing and another stitch is selected (other
than the buttonhole, bartack or darning stitch) and the Start/
Stop button is pressed while the buttonhole lever is lowered,
the LCD will display the warning message which reminds
you to raise the buttonhole lever.
Note
A-87
A-91
A-90
A-92 A-93
A-86 A-88 A-89
0
A-87
A-91
A-90
A-92 A-93
A-86 A-88 A-89
0
502020.83.11_2013_06_bernette chicago 7_EN