51
Basic Sewing Procedures
• Lead the upper thread down through the hole in the
presser foot.
• Pull down the buttonhole lever.
• The buttonhole lever is positioned behind the bracket
on the buttonhole foot.
• Gently hold the end of the upper thread in your left
hand, and then start sewing.
Darning stitches are sewn from the front of the presser foot to
the back, as shown.
• If the sewing range is too big to sew,
– then we recommend to sew the area several times
(or cross sew) to get better sewing result.
Position the fabric so that the needle is 2mm (1/16 inch) in
front of the area to be darned, and then lower the presser
foot.
When lowering the presser foot, do not push the front of the
presser foot, otherwise the darning will not be sewn in the
correct size.
Note
502020.83.11_2013_06_bernette chicago 7_EN
To Next Page
Loading...
