Berthold LB 4700 - 10 Plan for Visual Inspection of the Detector

Safety Manual / Explosion Protection Manual 10 Plan for Visual Inspection of the
Dt t
56926BA26, Rev. 06, 04/2019
25
10 Plan for Visual Inspection of the
Detector
IMPORTANT
If you answer any of these questions with "No", you must make a note of the
measures you have taken to remedy this deficiency in the last column. Before
you take the detector into operation, make sure to verify the correctness of the
measures with your explosion protection officer again.
Date:………………..
Name:………………………………..
Yes
No
Measures
General examination
Is the housing free from corrosion, dents,
cracks, holes and deformation?
Is the cover of the detector mounted firmly?
Are the safety-relevant temperatures (ambi-
ent temperature and temperature classes)
met according to chapter 6?
Are the outer terminals of the equipotential
bonding intact?
Is the surface of the detector free from con-
tact with other, non-alloy steel parts?
Are the connected cables mounted strain-re-
lieved?
Is a circuit break installed?
Is the circuit break easily
accessible by
maintenance personnel?