Appendix B: Optional Appliance Configuration
Configuring iDRAC
You can use the iDRAC tool to remotely manage your UVM appliance (UVM20 or UVM50). Configuring iDRAC is
optional.
For more information about configuring iDRAC, refer to Dell product documentation.
1. At startup, press F2 to enter the Setup menu.
2. Select iDRAC Settings.
3. Select Network.
4. Set "Enable NIC" to Enabled.
5. Configure IP address settings as per your Network Administrator (DHCP/Static).
Setting NIC selection to Dedicated only allows the physical iDRAC port on the back to be used for iDRAC
communication. Setting it to another port will allow it to share the same physical connection.
6. Save your settings.
If using DHCP IP configuration, watch for the iDRAC IP address to be displayed at start up and record this for future
use.
Open a browser and enter the IP address associated with the iDRAC port. Use the default logon credentials:
User: root
Password: calvin
iDRAC Commands
The below commands can be used to configure iDRAC settings from a Windows command prompt.
For the complete user guide with all supported commands go to http://search.dell.com and search for “RACADM
Command Line Reference Guide”.
Enable
Racadm setniccfg -o
Set useraccount
racadm
config
-g
cfgUserAdmin
-o
cfgUserAdminPassword
-i
2
<password>
Set Static IP
racadm setniccfg -s < IPv4Address> < netmask> < IPv4 gateway>
Set DHCP on
racadm setniccfg -d
Get Info
Racadm getniccfg
Appendix B: Optional Appliance Configuration
UVM Appliance User Guide 57 © 2018. BeyondTrust Software, Inc.
To Next Page
Loading...