103
Message
: Channel numbers have been reset in some audio I/O blocks.
Re-compile to update the channel number assignments.
Explanation
: Channel numbers were assigned in an input/output object, and that
object was assigned to a specific Audia unit by fixed alllocation.
Therefore, the channel numbers also became fixed. Then the
Audia I/O configuration was changed in the Equipment Table.
Since the new I/O configuration has less input or ouput channels,
some channel numbers have become invalid.
Once reset, Compile will automatically re-assign channel numbers.
Message
: Nothing to compile !
Explanation
: All objects placed in layout have been ignored.
Messages
: Insufficient audio inputs and outputs to implement this layout.
Insufficient audio inputs to implement this layout.
Insufficient audio outputs to implement this layout.
Explanation
: The design requires more input/output channels than are available
from the Audia device(s) specified in the Equipment Table. This
can only occur if the flag 'Auto Device Add' is not set under
Tools>Options>Compile.
Message
: Insufficient computing power to implement this layout.
Explanation
: The design requires more DSP resources than are available
from the Audia device(s) specified in the Equipment Table. This
can only occur if the flag 'Auto Device Add' is not set under
Tools>Options>Compile.
Message
: Feedback loop detected.
Explanation
: The potential exists for an audio path to be indirectly looped back
upon itself. This condition could be dangerous, and is not allowed.
To Next Page
Loading...
