Need help?Do you have a question about the Biamp AudiaFLEX and is the answer not in the manual?
Details technical specifications for Audia hardware configurations and expanders.
Manages hardware devices, I/O assignments, and network settings for system design.
Analyzes system design, checks for errors, and determines DSP resource allocation.
Guides on selecting and placing processing blocks into the system layout.
Explains how to create wiring connections between component object nodes.
Details how to view and edit control settings for individual DSP blocks.
Covers analysis, DSP allocation, network assignments, and error checking during compilation.
Describes the recommended procedure for compiler-based channel number assignment.
Lists common compile errors and their explanations for troubleshooting system designs.
Explains network requirements, cable types, and limitations for Audia systems.
Covers manual IP address assignment and considerations for single/multiple Audia units.
Explains the syntax for SET, GET, INC, DEC, RECALL, and DIAL commands for device control.
Lists attributes for input/output blocks, their supported commands, and value ranges.
Details attributes for automixer, matrix, and standard mixer blocks with command support.
Lists attributes for graphic EQ, HPF, LPF, shelf, and all-pass filters with command details.
Covers attributes for crossover blocks, including cutoff frequencies and slopes.
Covers attributes for leveler, comp/limiter, ducker, noise gate, and ANC with command details.
General| Software | Audia software |
|---|---|
| Sample Rate | 48 kHz |
| Bit Depth | 24-bit |
| Signal Processing | Acoustic Echo Cancellation (AEC), Noise Reduction, Automatic Gain Control (AGC), Compression, EQ, Crossover, Delay, Level Control, Metering, Routing |
| Control Interface | Ethernet, RS-232 |
| Network Connectivity | Ethernet |
| Compatibility | Windows |
To Next Page
