24
Disconnect From System
Ends communications with selected Audia
®
systems on the
network. See System Network Considerations. System design
data is retained in software after disconnect.
Send Configuration
Transmits system design data to selected Audia
®
devices in the
system. See System Network Considerations. Before data can be
transmitted, a system design file (.DAP) must first be opened, then
connected to a system, and have
Audia device IP addresses assigned
(see Device Maintenance). Send Configuration will
automatically Compile the system design, and reset the hardware
devices, before sending the new configuration.
Sync Data
Re-synchronizes the software with all connected Audia
®
devices in the system.
NOTE: An 'Auto-Update' feature now allows software to detect system changes,
and automatically re-synchronize with the devices where changes have occurred.
Start Audio
Enables audio signal flow within the selected system. See
System Network Considerations. Start Audio is available
only after Send Configuration has been successfully performed.
Stop Audio
Disables audio signal flow within the selected system.
See System Network Considerations.
To Next Page
Loading...
