52
EXPI
EXPI blocks are similar to CobraNet Input blocks, except they are
designed for use with AudiaEXPI hardware specifically and, therefore,
automatically allow for Internal Propagation Delay. CobraNet Input
blocks may be used with AudiaEXPI hardware, but Internal
Propagation Delay must be manually set (1.00mS).
Adjust AudiaEXPI input trim (gain) controls so that Peak In flashes
only occasionally (6dB headroom). Mute In turns the input signal
on/off. Level In adjusts the relative input volume. Invert In reverses
the polarity of the input signal.
CobraNet Bundle assigns digital audio data to a particular bundle
number. CobraNet Bundle Numbers are used to match those of the
actual AudiaEXPI hardware being used in the system. Normally,
'unicast' bundles 256 ~ 61,439 are selectable. These are device
specific bundles (for exchange of digital audio with only one other
device). Multicast allows selection of bundles 1 ~ 255, which are not
device specific (for exchange of digital audio with multiple devices).
Enable turns on/off the exchange of CobraNet digital audio data from
this device.
Right-clicking over certain settings will provide a menu of additional
options.
EXPO
EXPO blocks are similar to CobraNet Output blocks, except they are
designed for use with AudiaEXPO hardware specifically and, therefore,
automatically allow for Internal Propagation Delay. CobraNet Output blocks
may be used with AudiaEXPO hardware, but Internal Propagation Delay
must be manually set (0.33mS).
Mute Out turns the output signal on/off. Level Out adjusts the relative
output volume. Invert Out reverses the polarity of the output signal.
CobraNet Bundle assigns digital audio data to a particular bundle.
CobraNet Bundle Numbers are used to match those of the actual
AudiaEXPO hardware being used in the system. Normally, 'unicast'
bundles 256 ~ 61,439 are selectable. These are device specific bundles
(for exchange of digital audio with only one other device). Multicast
allows selection of bundles 1 ~ 255, which are not device specific (for
exchange of digital audio with multiple devices). Enable turns on/off the
exchange of CobraNet digital audio data from this device.
Right-clicking over certain settings will provide a menu of additional options.
To Next Page
Loading...
