Power- On State
The initial Power-On state of the power supply can be congured (voltage, current, output state) by the following the
steps below:
• From the menu, press the button 3 times to select POWER-ON STATE and press .
• The mode is showing on the display, press the button. There are four options which can be selected using the
rotary knob:
– DISABLE: Last voltage and current values before power o and output state is OFF.
– *RST: Reset output settings, voltage, current, output state, slew rate.
– LAST: Last voltage, current, and output state values before power OFF.
– USER: User dened voltage, current, and output state.
• Select one of the settings wanted during power up, and press to save changes. If USER has been selected,
set user dened memory and output state.
• Press several times to exit the menu setting.
To Next Page
Loading...
Need help?
General
