Black Box LES1508A - Send Email; Send SMS; Send SNMP Trap; Send Nagios Event

_____________________________________________________________________
724-746-5500 | blackbox.com Page 168
Note: A message text can be sent with Email, SMS, and Nagios actions. This configurable message
can include selected values:
$AR_TRIGGER_VAL = the trigger value for the check e.g. for UPS Status, it could be onbatt or
battlow
$AR_VAL = the value returned by the check e.g. for ups status, it could be online/onbatt/battlow
$AR_CHECK_DEV = the device name of the device being checked e.g. for Alarm, the alarm
name
$TIMESTAMP = the current timestamp.
$HOSTNAME = the hostname of the console server.
The default message text is: $TIMESTAMP: This action was run - Check details: value $AR_VAL
vs trigger value $AR_TRIGGER_VAL
7.3.1 Send Email
 Click on Send Email as the Add Trigger Action. Enter a unique Action Name and set the
Action Delay Time.
 Specify the Recipient Email Address to send this email to and the Subject of the email. For
multiple recipients, you can enter comma-separated addresses.
 Edit the Email Text message to send and click Save New Action.
Note An SMS alert can also be sent via an SMTP (email) gateway. You will need to specify the
Recipient Email Address in the format specified by the gateway provider (e.g. for T-Mobile it is
phonenumber @tmomail.net).
7.3.2 Send SMS
 Click on Send SMS as the Add Trigger Action. Enter a unique Action Name and set the
Action Delay Time.
 Specify the Phone number that the SMS will be sent to in international format (without the +).
 Edit the Message Text to send and click Save New Action.
Note: The SMS alert can only be sent if there is an internal or external USB cellular modem attached.
An SMS alert can also be sent via a SMTP SMS gateway as described above.
7.3.3 Send SNMP Trap
 Click on Send SNMP Trap as the Add Trigger Action. Enter a unique Action Name and set
the Action Delay Time.
Note: The SNMP Trap actions are valid for Serial, Environmental, UPS, and Cellular data triggers only.
7.3.4 Send Nagios Event
 Click on Send Nagios Event as the Add Trigger Action. Enter a unique Action Name and
set the Action Delay Time.
 Edit the Nagios Event Message text to display on the Nagios status screen for the service.
 Specify the Nagios Event State (OK, Warning, Critical or Unknown) to return to Nagios for
this service.