Black Box LES1508A - Set up Earlier Windows Clients; Set up Linux Clients for Dial-In; Dial-Out Access; Always-On Dialout

_____________________________________________________________________
724-746-5500 | blackbox.com Page 97
!
PDCDU% F3/%)2%3',*#3,%^#(50G$%A*#3(/$%

[2(!i$,52/%!HBBBE!3#'!WWW!6.$',3!%'3!-N!N(26'5-('!$%!3#'!%+O'!+%!+R2<'E!'96'N3!12-!4'3!32!3#'!
=#'*V?2%@3/G0,H#(-%Z0*53,!R1!6.$60$,4!3#'!F/',/!R-332,!+,5!%'.'63$,4!F3//#(-$D!"#',E!6.$60!
@3/G0,H%'(5%=#'*V)2%70((3A/#0($%+,5!6.$60!&'H3%@3G%70((3A/#0(D%

;$O$.+(.1E!72(!i$,52/%!`CE!12-!52-R.'!6.$60!&1%7062)/3,!2,!3#'!X'%032NE!3#',!2N',!=#'*V?2%
@3/G0,H#(-!+,5!52-R.'!6.$60!&'H3%@3G%70((3A/#0(M!"#',E!N(26''5 !+ %!+R 2 < 'M!
!
PDCDP% F3/%)2%N#():%A*#3(/$%40,%5#'*V#(%
"#'!2,.$,'!3-32($+.!#33NV__///M12.$,-9M62O _"&"QLUD>;_>$,-9"-32($+.WWWM#3O.!N('%',3%!+!%'.'63$2,!27!
O'3#25%!72(!'%3+R.$%#$,4!+!5$+.!-N!WWW!62,,'63$2,V!
- :2OO+,5!.$,'!WWW!+,5!O+,-+.!62,7$4-(+3$2,!=/2(0%!/$3#!+,1!>$,-9!5$%3($R-3$2,JM!
- &%$,4!3#'!C.#U8!"#-!62,7$4-(+3$2,!322.!=72(!L'5!\ +3!62 O N +3$R .'!5$%3($R -3$2 ,% JM!"#$% !62, 7$4- ('%!
3#'!%6($N3%'.-U9 S.- 3" 0#!32!%3+(3!+,5!%32 N!+!WW W!62 ,, '6 3$2,M!
- &%$,4!3#'!Z,2O'!62,3(2.!N+,'.!62,7$4-(+3$2,!322.M!
- i]XUD>!+,5!3#'!L'5#+3!PX$+.-N!62,7$4-(+3$2,!322.P!M!
- Z&U!5$+.!N(24(+O!eK$%NM!X2/,.2+5_U,%3+..+3$2,_:2,7$4-(+3$2,M!
Note
For all PPP clients:
 Set the PPP link up with TCP/IP as the only protocol enabled.
 Specify that the Server will assign IP address and do DNS.
 Do not set up the console server PPP link as the default for Internet connection.
%
5.3 Dial-Out Access
The internal or externally attached modem on the console server can be set up either:
- in Failover mode where a dial-out connection is only established in event of a ping failure, or
- with the dial-out connection always on.
In both of the above cases, if the dial-out connection is disrupted, the console server will try to
re-establish the connection.
5.3.1 Always-on dial-out
With V3.4 firmware (and later) the console server modem can be configured for out-dial to be always on,
with a permanent external dial-up ppp connection.
 Select the System: Dial menu option and check Enable Dial-Out to allow outgoing modem
communications.
 Select the Baud Rate and Flow Control that will communicate with the modem.
 In the Dial-Out Settings - Always On Out-of-Band field enter the access details for the
remote PPP server to be called.