ServSwitch™ DKM
14
1 Quick Setup
This section briefly describes how to install your ServSwitch™ DKM system. Unless you are
an experienced user, we recommend that you follow the full procedures described in the rest
of this manual.
Installation of the system
Connect ServSwitch™ DKM to Local unit(s) with CATx/Fibre cable(s).
Connect ServSwitch™ DKM to Remote unit(s) with CATx/Fibre cable(s).
Connect the devices to the power supplies.
Power up the system.
Done
YES
NO
Link LED
illuminated?
NO
YES
Check p.s.u.’s and connection to
power outlet
Power LED
illuminated?
Check the CATx- cable, and
CATx- connectors
To Next Page
Loading...
