8.5.3 iH Single Equipment Monitor and iH Fabworks
The iH Single Equipment Monitor allows you to monitor pump parameters and configure the
iH system. The iH Fabworks allows you to network together all of the iH systems in your
installation, and to use a PC to centrally monitor the iH systems. Contact your supplier or
BOC Edwards if you want to network your iH systems.
8.5.4 iH PC Interface Kits
The iH PC Interface Kit allows you to directly connect the iH system to a laptop PC or to a
desktop PC and to use the PC to switch the iH system on and off, and to monitor the status of
the iH system. The Kit is supplied with all necessary cables and with the iH Single
Equipment Monitor software.
Accessory Item Number
Desktop PC Interface Kit D372-18-100
Laptop PC Interface Kit (USA) D372-18-200
Laptop PC Interface Kit (Europe) D372-18-300
Laptop PC Interface Kit (UK) D372-18-400
Laptop PC Interface Kit (Japan) D372-18-500
PCMCIA Laptop PC Interface Kit D372-17-000
8.5.5 iH Alternative Connections Kits
Use this kit to reconfigure the iH system to use the alternative nitrogen inlet and/or
cooling-water inlet and outlet connection positions (see Section 3.5).
Accessory Item Number
Alternative Nitrogen and Cooling-Water Connections Kit A505-34-000
8.5.6 iH Alternative Exhaust Kit
This kit provides the user with O-rings and insulation jackets to fit to the exhaust pipe in the
reversed position.
Accessory Item Number
iH Alternative Exhaust Kit A505-33-000
8.5.7 iH Nitrogen Flow Switch
When installed, the Flow Switch enables the iH communications Module to monitor the flow
of nitrogen purge gas to the dry pumping system, and shut down the dry pumping system if
the flow is too low.
Accessory Item Number
iH Nitrogen Flow Switch A532-54-000
8-4 iH Dry Pumping Systems
To Next Page
