Boeing 787-8 - Page 127

787 Flight Crew Operations Manual
DO NOT USE FOR FLIGHT
Normal Procedures -
Amplified Procedures
Copyright © The Boeing Company. See title page for details.
D615Z003-TBC NP.21.41
Pilot Flying Pilot Monitoring
At the same time:
• push the TO/GA switch
• call “FLAPS 20”
Position the flap lever to 20.
Verify:
• the rotation to go–around attitude
• that the thrust increases
Verify that the thrust is sufficient for the
go-around or adjust as needed.
Verify a positive rate of climb on the
altimeter and call “POSITIVE RATE.”
Verify a positive rate of climb on the
altimeter and call “GEAR UP.”
Set the landing gear lever to UP.
Above 400 feet radio altitude, verify or
select a roll mode.
Verify that the missed approach altitude is
set.
Verify that the missed approach route is tracked.
At acceleration height, set speed to the
maneuver speed for the planned flap
setting.
Call “FLAPS___” according to the flap
retraction schedule.
Set the flap lever as directed.
After flap retraction to the planned flap
setting, select FLCH or VNAV as needed.
Verify that climb thrust is set.
Verify that the missed approach altitude is captured.
Call “AFTER TAKEOFF CHECKLIST.” Do the AFTER TAKEOFF checklist.
February 15, 2010