Operating Instructions ACTIVE06/07 9
06/07 Operating Instructions ACTIVE 9
1.2 Purpose of the Frequency Inverters
Warning! The frequency inverters are electrical drive components intended for
installation in industrial plants or machines. Commissioning and start of
operation is not allowed until it has been verified that the machine
meets the requirements of the EC Machinery Directive 98/37/EEC and
EN 60204. In accordance with the CE marking requirements, the fre-
quency inverters also comply with the Low Voltage Directive 72/23/EEC
as well as EN 50178 / DIN VDE 0160 and EN 61800-2. The user shall be
responsible for making sure that the requirements of the EMC Directive
89/336/EEC are met. Frequency inverters are only available at special-
ized dealers and are exclusively intended for professional use as per
EN 61000-3-2.
The frequency inverters are also marked with the UL label according to
UL508c, which proves that they also meet the requirements of the
CSA Standard C22.2-No. 14-95.
The technical data, connection specifications and information on ambi-
ent conditions are indicated on the name plate and in the documentation
and must be complied with in any case. Anyone involved in any kind of
work at the device must have read the instructions carefully and under-
stood them before starting the work.
1.3 Transport and Storage
The frequency inverters must be transported and stored in an appropriate way. Dur-
ing transport and storage the devices must remain in their original packaging. The
units may only be stored in dry rooms which are protected against dust and moisture
and are exposed to little temperature deviations only. Observe the climatic conditions
according to EN 50178 and the marking on the packaging. The frequency inverters
must not be stored for more than one year without connecting them to nominal volt-
age.
1.4 Handling and Installation
Warning! Damaged or destroyed components must not be put into operation be-
cause they may be a health hazard.
The frequency inverters are to be used in accordance with the documentation as well
as the applicable directives and standards. They must be handled carefully and pro-
tected against mechanical stress. Do not bend any components or change the isolat-
ing distances. Do not touch any electronic components or contacts. The devices are
equipped with components which are sensitive to electrostatic energy and can easily
be damaged if handled improperly. Any use of damaged or destroyed components
shall be considered as a non-compliance with the applicable standards. Do not re-
move any warning signs from the device.
To Next Page
Loading...
Need help?
General
