Operating Instructions ACTIVE06/07 65
06/07 Operating Instructions ACTIVE 65
Activation via CM Communication Module
Attention! Activation of the control unit via a communication connection is only
possible if the frequency inverter is equipped with an optional CM com-
munication module and the communication is effected via this module.
For this purpose, the control unit must be connected to the frequency
inverter.
• Establish a communication connection to the frequency inverter.
• Start the communication and select parameter Program(ing) 34 via the commu-
nication interface.
• Via the communication interface, enter and confirm the value 111 in parameter
Program(ing)
34.
• Via the communication interface, enter and confirm the value 123 in parameter
Program(ing)
34.
Frequency inverter is initialized again. The display of the control unit reads
"rESEt". Then, the initialization operation is started.
6.6.2 Transfer data
In order to transmit a file from the control unit to the frequency inverter, proceed as
follows:
• Connect the KP 500 control unit to the frequency inverter.
After the initialization, the data sources which are available for download are dis-
played.
• Use the arrow keys to select the data source (Src.F.y) for the copy operation from
the control unit to the frequency inverter.
The files stored in the control unit can be used as data sources.
Note: The files stored in the control unit contain all information and pa-
rameters stored in the control unit according to the selected copy
function ALL or Act (see Chapter “Copy Menu (CPY)”).
• Confirm the selection by pressing the ENT key.
The copy operation is started. The message COPY and the number of the cur-
rently processed parameter will be displayed to indicate the progress of the opera-
tion.
After the copy operation is complete, the control unit is initialized again.
To Next Page
Loading...
Need help?
General
