Operating Instructions ACTIVE 06/0788
88 Operating Instructions ACTIVE 06/07
8.8 Language
The parameters are stored in the frequency inverter in various languages. The pa-
rameter description is displayed in the selected
Language 33, e.g. by the PC program
VPlus,.
Language 33 Function
0 - Deutsch Parameter description in German.
1 - English Parameter description in English.
2 - Italiano Parameter description in Italian.
8.9 Programming
The parameter
Program(ming) 34 enables acknowledgment of a fault message and
resetting to the factory settings. The display of the control unit reads "dEFLt" or "rE-
SEt" and the LEDs indicate the status of the frequency inverter.
Program(ming) 34 Function
111 - Parameter transfer
The KP 500 control unit is prepared for parameter trans-
mission. A connected frequency inverter can receive data
from the control unit.
110 - Normal mode Reset the KP 500 control unit to standard mode.
123 - RESET
The current error message can be acknowledged via
digital input S1IND or the software parameter. The dis-
play of the control unit reads "rESEt".
4444 - Default
The parameters of the selected configuration are over-
written - except for a few exceptions - by the default
settings. The display of the control unit reads "dEFLt".
Note:
The parameters
Control Level 28, Language 33 as well as Configura-
tion
30 are not changed during the reset to the default settings (Pro-
gram(ing)
34 = 4444).
To Next Page
Loading...
Need help?
General
