Bosch rexroth SE 2/C Series - Page 29

Fig. 14:
max. 2000 mm
5
5
50
45
358 736-23
5
5
M
D
= 25 Nm
SW13
M
D
= 25 Nm
SW13
M
D
= 25 Nm
SW13
M
D
= 25 Nm
SW13
ST2/C-H ST2/R-H ST2/R-V
D
1
)
Assembling the section ST 2/C-H, ST 2/R-H, ST 2/R-V on leg sets (2/2)
1. Install the fi rst section
ST 2/... on two leg sets
and align it.
2. Install the subsequent
sections and leg sets
fl ush and horizontally.
Please note:
• Support each section
joint and the ends of the
section with leg sets.
• Max. distance between
2 leg sets: 2000 mm.
• At both ends of the
section, the guide profi le
must protrude by 5 mm
in each case in order to
bridge the adapter plates
for mounting the drive
module or return unit.
3. Install the adapter
plates (D) at the ends
of the section with the
cylinder pins.
1
) Adapter plate (D) for
connection of the drive
module or return unit
– ST 2/C-H: 3 842 536 801
1
)
3 842 560 610
2
)
– ST 2/R-H: 3 842 536 800
1
)
3 842 560 609
2
)
– ST 2/R-V: 3 842 536 802
1
)
3 842 560 611
2
)
1
) Previous version of the
section profi le (see page 19
/ 95).
2
) New version of the section
profi le (see page 19 /
95).
Assembly 29/108
3 842 358 737/2022-08, MIT: SE 2/C-…, SE 2/R-…, Bosch Rexroth AG
ENGLISH