Brady BMP 71 - Applying Attributes to Existing Text

47
Formatting
Font
BMP71 User’s Manual
Pre-Existing Data
To apply an attribute to previously entered text:
1. Hold Shift while moving the cursor across the characters on which the attribute will
take affect.
This highlights the data.
NoteNote
Highlighting works on a line-by-line basis. You cannot highlight more than one line
at a time.
2. Press Font .
3. Choose the attribute, then choose ON.
4. Press OK or Enter .
All highlighted text displays the attribute.
NoteNote
To remove the highlighting from the characters, press any navigation key.
To remove an attribute that was previously applied to some text:
1. Hold Shift while moving the cursor across the characters from which the attribute
will be removed.
2. Press Font .
3. Choose the attribute, then choose OFF.
1. Press OK or Enter .
The attribute is removed from the text.