Brady BradyPrinter S3700 - Page 115

BradyPrinter S3700 User Manual 106
Troubleshooting
Error reading media memory cell.
Error 48
Media sensor cannot detect
supply type.
Remove and replace media.
See Loading Supplies on page 15.
Clean Sensors on page 97.
If the error persists, contact
Technical Support.
Error reading media memory cell.
Error 49
Printer cannot read/write to the
smart cell.
Remove and replace labels.
See Loading Supplies on page 15.
Clean Sensors on page 97.
If the error persists, contact
Technical Support.
Error reading media memory cell.
Error 50
Data may be corrupted. Open cover and install label
correctly. The message
automatically clears.
If error persists, contact Technical
Support.
Error reading media memory cell.
Error 51
The smart cell is the wrong
version.
- or -
Printer class is not valid.
- or -
Printer version is not valid.
Open cover, remove and re-install
labels. The message
automatically clears.
If error persists, contact Technical
Support.
Media remaining value has
reached 0.
Error 52
Label or ribbon has been
exhausted.
Replace the depleted supply.
See Loading Supplies on page 15.
Media sensor shows end of
media.
Error 53
Label supply has been used up or
is incorrectly installed.
Insert a new label roll if used up.
- or -
Feed the leading edge of the
labels past the indicator and verify
media guides are positioned
correctly. See Installing Labels on
page 17.
Error/Severity Cause Corrective Action