100-214-276 Rev. 3 1-7
2000X aed Actuator Chapter 1: Safety and Support
Instruction Manual Warranty Statement, Disclaimer
• EN 60204-1 Safety of Machinery - Electrical Equipment of machines
• EN 60529 Degrees of protection provided by enclosure
• EN 60664-1 Insulation coordination for equipment within low-voltage systems
• EN 61000-3-3 Electromagnetic Compatibility - Limitations of voltage fluctuations and flicker
in low voltage supply systems (for European products that draw less than 1000 watts from
the line at full rated power)
• EN 61000-6-2 Electromagnetic Compatibility - Generic standards - Immunity for industrial
environments
• EN 61310-2 Safety of Machinery - Indication, marking, actuation
• NFPA 70 National Electrical Code Article 670 Industrial Machinery
• NFPA 79 Electrical Standard for Industrial Machinery
• 29 CFR 1910.212 OSHA General Requirements for all machines
• 47 CFR Part 18 Federal Communication Commission
All products with CE Mark require: Same as above plus
• EN 61000-3-2 Electromagnetic Compatibility - Limits for harmonic emissions (for European
products that draw less than 1000 watts from the line at full rated power)
Figure 1.5 CE Mark
1.3 Warranty Statement, Disclaimer
The following excerpts from the “Terms and Conditions of Sale” (found on the back of your
Invoice) are essential guidelines for the product Warranty issued with your Branson ultrasonic
welding components. The items listed in this section specifically address issues involving the
delivery, shipment, and warranty period provided. If you have any questions, please refer to the
back of the Invoice included with your system, which lists all of the Terms and Conditions of
Sale, or contact your Branson representative.
TERMS AND CONDITIONS OF SALE
Branson Ultrasonics Corporation is herein referred to as the “Seller” and the customer or person
or entity purchasing products (“Products”) from Seller is referred to as the “Buyer.” Buyer’s
acceptance of the Products will manifest Buyer’s assent to these Terms and Conditions.
DOC EXPIRES 12PM 7/24/2012. Article or Material must comply with the requirements
stipulated by RoHS in its current version
To Next Page
Loading...
Need help?
General
