100-214-276 Rev. 3 i
2000X aed Actuator
Instruction Manual
Chapter 1: Safety and Support
1.1 Safety Requirements and Warnings - - - - - - - - - - - - - - -1 - 2
1.1.1 Symbols Found in this Manual - - - - - - - - - - - - - - - - -1 - 2
1.1.2 Symbols Found on the Product - - - - - - - - - - - - - - - - -1 - 2
1.2 General Precautions - - - - - - - - - - - - - - - - - - - - - - -1 - 4
1.2.1 Intended Use of the System - - - - - - - - - - - - - - - - - -1 - 6
1.2.2 Safety Measures and Guards- - - - - - - - - - - - - - - - - -1 - 6
1.2.3 Emissions - - - - - - - - - - - - - - - - - - - - - - - - - - -1 - 6
1.2.4 Setting up the Workplace- - - - - - - - - - - - - - - - - - - -1 - 6
1.2.5 Regulatory Compliance - - - - - - - - - - - - - - - - - - - -1 - 6
1.3 Warranty Statement, Disclaimer - - - - - - - - - - - - - - - - -1 - 7
1.4 How to Contact Branson - - - - - - - - - - - - - - - - - - - - 1 - 10
1.4.1 Before Calling Branson for Assistance - - - - - - - - - - - - 1 - 10
1.5 Returning Equipment for Repair - - - - - - - - - - - - - - - - 1 - 11
1.5.1 Get an RGA Number - - - - - - - - - - - - - - - - - - - - - 1 - 12
1.5.2 Record information about the Problem - - - - - - - - - - - - 1 - 12
1.5.3 Departments to Contact - - - - - - - - - - - - - - - - - - - 1 - 13
1.5.4 Pack and Ship the Equipment - - - - - - - - - - - - - - - - 1 - 14
1.6 Obtaining Replacement Parts- - - - - - - - - - - - - - - - - - 1 - 14
Chapter 2: Introduction to the 2000X aed Actuator
2.1 Models Covered- - - - - - - - - - - - - - - - - - - - - - - - - -2 - 1
2.1.1 Power Supply Manual Set - - - - - - - - - - - - - - - - - - -2 - 3
2.2 Overview of this Model - - - - - - - - - - - - - - - - - - - - - -2 - 3
2.3 Features of the System - - - - - - - - - - - - - - - - - - - - - -2 - 4
2.4 Controls and Indicators- - - - - - - - - - - - - - - - - - - - - -2 - 6
2.5 Welding Systems - - - - - - - - - - - - - - - - - - - - - - - - -2 - 7
2.6 Glossary of Terms - - - - - - - - - - - - - - - - - - - - - - - -2 - 9
Table of Contents
DOC EXPIRES 12PM 7/24/2012. Article or Material must comply with the requirements
stipulated by RoHS in its current version
To Next Page
Loading...
Need help?
General
