Branson 2000X Series - Installation and Setup

100-214-276 Rev. 3 4-1
2000X aed Actuator Chapter 4: Installation and Setup
Instruction Manual
Chapter 4: Installation and Setup
4.1 About Installation- - - - - - - - - - - - - - - - - - - - - - - - - 4-2
4.2 Handling and Unpacking - - - - - - - - - - - - - - - - - - - - - 4-2
4.2.1 Unpack the Power Supply - - - - - - - - - - - - - - - - - - - 4-3
4.2.2 Unpack the Stand or Actuator - - - - - - - - - - - - - - - - - 4-3
4.2.3 Stand (actuator on a base)- - - - - - - - - - - - - - - - - - - 4-4
4.2.4 Stand (Actuator on a Hub)- - - - - - - - - - - - - - - - - - - 4-6
4.2.5 Actuator (Alone)- - - - - - - - - - - - - - - - - - - - - - - - 4-7
4.3 Take Inventory of Small Parts - - - - - - - - - - - - - - - - - - 4-7
4.3.1 Cables - - - - - - - - - - - - - - - - - - - - - - - - - - - - 4-8
4.4 Installation Requirements - - - - - - - - - - - - - - - - - - - - 4-9
4.4.1 Location - - - - - - - - - - - - - - - - - - - - - - - - - - - - 4-9
4.4.2 Environmental Specifications- - - - - - - - - - - - - - - - - - 4-10
4.4.3 Electrical Input Power Ratings - - - - - - - - - - - - - - - - - 4-10
4.4.4 Air Cylinder Consumption - - - - - - - - - - - - - - - - - - - 4-11
4.4.5 Factory Air- - - - - - - - - - - - - - - - - - - - - - - - - - - 4-16
4.5 Installation Steps- - - - - - - - - - - - - - - - - - - - - - - - - 4-17
4.5.1 Mounting the Stand (Actuator on Base) - - - - - - - - - - - - 4-17
4.5.2 Mounting the Stand (Actuator on Hub-mounted column) - - - - 4-19
4.5.3 Actuator (Alone) - - - - - - - - - - - - - - - - - - - - - - - - 4-20
4.5.4 Mount the Power Supply - - - - - - - - - - - - - - - - - - - - 4-22
4.5.5 Input Power (Main) - - - - - - - - - - - - - - - - - - - - - - 4-23
4.5.6 Output Power (RF Cable) - - - - - - - - - - - - - - - - - - - 4-23
4.5.7 Interconnect between Power Supply and Actuator - - - - - - - 4-23
4.5.8 Start Switch Connection (Automation) - - - - - - - - - - - - - 4-24
4.5.9 Serial (RS-232) Port Connector - - - - - - - - - - - - - - - - 4-25
4.5.10 Parallel Printer Connector, 2000X time and 2000X energy only - 4-25
4.5.11 User I/O Interface - - - - - - - - - - - - - - - - - - - - - - - 4-26
DOC EXPIRES 12PM 7/24/2012. Article or Material must comply with the requirements
stipulated by RoHS in its current version