GENERAL
KUKJE MACHINERY CO., LTD.
16
< Replacing engine oil filter cartridge >
▶ Be sure to stop the engine before changing oil
filter cartridge.
1. Remove the oil filter cartridge with the filter
wrench.
2. Apply a slight coat of oil onto the cartridge
gasket.
3. To install the new cartridge, screw it in by hand.
Over tightening may cause deformation of
rubber gasket.
4. After the new cartridge has been replaced, the
engine oil normally decrease a little. Thus see
that the engine oil does not leak through the
seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the
specified level.
◈ Important
¾ To prevent serious damage to the engine,
replacement element must be highly efficient.
Use only a Branson genuine filter.
*. PART NAME
1) Engine oil filter
7. DISASSEMBLING AND SERVICING
To Next Page
Loading...
