Branson 2400 - Transmission and Axle Oil Service

GENERAL
KUKJE MACHINERY CO., LTD.
17
< Changing transmission fluid >
▶ Be sure to stop the engine before checking and
changing the transmission fluid.
1. Place an oil pan under the tractor.
2. Remove the drain plugs(1) at the bottom of the
rear axle cases, transmission case and front
transmission case.
3. Drain the transmission fluid.
4. After draining, screw in the four drain plugs.
5. Fill new oil from filling port after removing the
filling plug(2), up to the upper notch on the
dipstick.
6. After running the engine for a few minuets, stop
it and check the oil level again, if low, add oil to
proper level.
◈ Important
¾ Use only multi-grade transmission oil. Use of
other oils may damage the transmission of
hydraulic system.
¾ Never work the tractor immediately after
changing the transmission oil. Keep the engine
at medium speed for a few minutes to prevents
damage to the transmission.
Front case 3L (0.79gal)
2100
2400
2800
Rear case 13L (3.43gal)
Front case 3L (0.79gal)
Transmission
fluid capacity
2400h
2800h
Rear case 15L (3.96gal)
*. PART NAME
1) Drain plug 2) Filling plug
3) Dipstick
7. DISASSEMBLING AND SERVICING
(1)
(1)
(1)
(3)