GENERAL
KUKJE MACHINERY CO., LTD.
19
*. PART NAME
1) Stopper bolt 2) Clutch pedal rod
3) Lock nut for stopper bolt 4) Clutch housing
5) Satety switch 6) Clutch rod
< Checking clutch pedal free travel >
▶ When checking, park the tractor on flat ground,
apply the parking brake, stop the engine and
remove the key.
1. Slightly depress the clutch pedal and measure
stroke “A” at top of stopper bolt(1).
2. If the measurement is not within the factory
specifications, loosen the lock nut and adjust the
clutch pedal rod(2) length.
3. After adjusting it, measure total stroke “B”
between stopper bolt(1) and clutch housing(4).
4. If the measurement is not within the factory
specifications, adjust it with the clutch pedal
stopper bolt(1).
5. And at the same time, adjust the clearance “C”
between safety switch(5) and clutch rod(6).
▶ NOTE
1) After adjustment, secure the stopper bolt with
the lock nut(3).
Clutch pedal free travel on
stopper bolt stroke “A”
Factory
spec.
7.0 to 9.0 mm
0.28 to 0.35 in.
Reference :
Clutch pedal free travel “L”
on top of clutch pedal.
25.0 to 35.0 mm
0.98 to 1.38 in.
Clearance “B”
Factory
spec.
1.5 to 2.0 mm
0.06 to 0.08 in.
7. DISASSEMBLING AND SERVICING
<3> CHECK POINTS OF EVERY 50 HOURS
L
To Next Page
Loading...
