GENERAL
KUKJE MACHINERY CO., LTD.
20
*. PART NAME
1) Clutch pedal 2) Range shift
3) PTO gear shift 4) Speed control pedal
5) Main gear shift
< Checking engine start system >
▶ Do not allow anyone near the tractor while
testing.
▶ If the tractor does not pass the test do not
operate the tractor.
▷ Preparation before testing
1. Sit on operator’s seat.
2. Set the parking brake and stop the engine.
3. HST type
-. Shift the range gear shift lever to “Neutral”
position.
-. Place the speed control pedal in “Neutral”
position.
Manual transmission type
-. Shift the main gear shift lever in “Neutral”
position.
4. Shift the PTO gear shift lever to “Neutral”
position.
5. Fully depress the clutch pedal.
▷ Test 1 : Safety switch for clutch pedal
1. Place the speed control pedal in “Neutral”
position for a HST type or shift the main gear
shift lever for a Manual transmission type to
“Neutral” position.
2. Release the clutch pedal.
3. Turn the key to “Start” position.
4. The engine must not crank.
7. DISASSEMBLING AND SERVICING
To Next Page
Loading...
